Klipsch Palladium P-27C Manuel d'utilisateur télécharger pdf (Page 5)

Page 5

Preparing the Loudspeaker

ConnectionProcedure:

There is a speciﬁc procedure to be followed:

• Switch o and unplug the amplier/s and all source electronics from the mains power.

• Place both loudspeakers in the general area where you want them.

• Connect each loudspeaker following the instructions under the “connecting the loudspeakers” section of

this manual.

• Attach the spikes, following the instructions under the “nalizing the assembly” section of this manual

• Run both sets of loudspeaker cable to the amplier

• Connect the amplier

• Finalize the position of the loudspeakers.

• Finally, t the grilles (if desired)

TAKECARENOTTOTOUCHTHEDRIVEUNITSWHENYOUMOVETHELOUDSPEAKERSAROUND.

TOPRESERVETHEFINISH,WHENHANDLINGYOURSPEAKERS,USETHEGLOVESTHATAREPROVIDED.

FittingandRemovingtheGrilles

The grilles are magnetically attached to the cabinet. Specially designed magnets

are housed inside the front wall of the loudspeaker, so that if you wish to operate

the loudspeaker with the grilles removed, no grille mounting hardware is visible.

This preserves the smooth lines of the loudspeaker.

To t the grilles: Fit the top grille rst and line it up with the top and sides of the

cabinet. For the P-38F, P-37F and P-17B there is a small lip on the top of the grille

that should rest on the top of the cabinet. Now, t the lower grille, lining up the

top of the lower grille with the bottom of the upper grille. You may now remove

the top grille if you wish. (The P-17B, P-27C and P-27S have a single one-piece

grille only.)

Although operating the loudspeakers with the grilles on or oﬀ is a matter

of personal taste, moving or connecting the loudspeakers should always be done

with the grilles removed. Be especially careful not to touch the drive units.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Pas de commentaire

Klipsch Palladium P-27C Manuel d'utilisateur Page 5